One Ball Scraper Triangle - Wax
This 6 -inch scraper, in the shape of a triangle, in acrylic, super sharp, allows you to have a good grip for a maximum lever effect to remove the wax from your board! All our plastic scrapers are made of high quality acrylic because it is extremely sharp. If your scraper has an accumulation of wax or is blurred, you can pass it on a steel file or sandpaper to clean it and give it back a new cutting edge. The serrated corner allows you to easily remove the wax from your edges.
6 "x 1/8" triangle thick
Instructions :
1. Choose the FART specific to the appropriate temperature by checking the mountain conditions/the snowball bulletin (real snow temperature, not air).
2. Press the Fart on the iron and distribute small drops of Fart over the entire base. Do not let the smoking iron!
3. The iron in hand, slowly pull on the wax drops by smoothing them to form a wax sheet which covers the whole base, from point to tail.
4. Let the wax cool for 10 to 15 minutes, then scratch it using a sharp plastic scraper. Do not use a steel scraper.
5. Using a wax brush or a fiber stamp, remove the excess wax from the base, brushing from the tip to the tail. This allows the base to slide quickly.
6 "x 1/8" triangle thick
Instructions :
1. Choose the FART specific to the appropriate temperature by checking the mountain conditions/the snowball bulletin (real snow temperature, not air).
2. Press the Fart on the iron and distribute small drops of Fart over the entire base. Do not let the smoking iron!
3. The iron in hand, slowly pull on the wax drops by smoothing them to form a wax sheet which covers the whole base, from point to tail.
4. Let the wax cool for 10 to 15 minutes, then scratch it using a sharp plastic scraper. Do not use a steel scraper.
5. Using a wax brush or a fiber stamp, remove the excess wax from the base, brushing from the tip to the tail. This allows the base to slide quickly.
