One ball hot wax kit - wax
No speed, no life!
There is nothing worse than an equipment that does not work. This limits your abilities and can make you spend a bad day. Make sure it is well maintained and that it is fast!
The hot wax adjustment kit includes:
Personalized Farter, two high performance waxes (X-Wax Cool and X-Wax Rub-on), a 6-inch plastic scraper, P-Tex candles, a fiberglass stamp, a personalized bag to transport everything What you need to adjust your equipment. Complete instructions.
There is nothing worse than an equipment that does not work. This limits your abilities and can make you spend a bad day. Make sure it is well maintained and that it is fast!
The hot wax adjustment kit includes:
Personalized Farter, two high performance waxes (X-Wax Cool and X-Wax Rub-on), a 6-inch plastic scraper, P-Tex candles, a fiberglass stamp, a personalized bag to transport everything What you need to adjust your equipment. Complete instructions.
Adjustment instructions:
1. Place the board or skis in a vice to fix them and clean the base with a new layer of hot wax and scrape it or use the basic one MFG cleaner.
2. Check that the side and the sole edges do not have burrs. Rub a ceramic, diamond or gum stone on the area to remove the burrs in preparation for the shaping of the squares.
3. Use the ONE MFG edge tool to sharpen the side edges. Start with the tip and pull gently with firm pressure to the tail. Proceed by regular passes until the edges are well sharpened. Repeat the operation on the other side. Do not forget to turn the file to turn over so that the teeth are oriented in the right direction ... Look for the arrow.
4. If you prefer that your board or skis do not hang on the spatula and the heel, Dam up them using a stone to be amazed to round the edges of the spatula and heel. Start with the squares going up to the spatula and the spatula and file up to about 1.5 "after the contact point of the crossroads, when your base is flat.
5. To obtain very clear edges, use a fine diamond stone or a polishing stone and go back to the edge using the same technique.
6. If you like to use rails and boxes, do not cross your edges much to prevent them from hanging on.
Keep your sharpening tool clean with the file to file!
Take advantage of your speed!
1. Place the board or skis in a vice to fix them and clean the base with a new layer of hot wax and scrape it or use the basic one MFG cleaner.
2. Check that the side and the sole edges do not have burrs. Rub a ceramic, diamond or gum stone on the area to remove the burrs in preparation for the shaping of the squares.
3. Use the ONE MFG edge tool to sharpen the side edges. Start with the tip and pull gently with firm pressure to the tail. Proceed by regular passes until the edges are well sharpened. Repeat the operation on the other side. Do not forget to turn the file to turn over so that the teeth are oriented in the right direction ... Look for the arrow.
4. If you prefer that your board or skis do not hang on the spatula and the heel, Dam up them using a stone to be amazed to round the edges of the spatula and heel. Start with the squares going up to the spatula and the spatula and file up to about 1.5 "after the contact point of the crossroads, when your base is flat.
5. To obtain very clear edges, use a fine diamond stone or a polishing stone and go back to the edge using the same technique.
6. If you like to use rails and boxes, do not cross your edges much to prevent them from hanging on.
Keep your sharpening tool clean with the file to file!
Take advantage of your speed!
